INVT EC160 User Manual

User manual of EC160 elevator intelligent integrated machine Function parameters
124
Function
code
Instruction Setting range【default value】 Remarks
T0_20 Beam keeping failure time 0~65535s【0】
Not modify
in running
When the elevator stops after fast arrival at the door area and opens the door, after the
continuous action time of the beam reaches the set value, the door can be closed manually.
6.5.18 Parameters setting---function setting
【main menu】
A
system control
B fault record
C language
selection
D parameters
setting inquiry
E password setting
F system
autotuning
G data
management
H system
information
【parameters setting
inquiry】
P0 master drive
control
P1 speed and
deceleration distance
P2 motor parameters
P3 encoder
parameters
P4 running
comfortability
P5 elevator protection
parameters
P6 communication
setting
P7 drive information
PE factory only
A
0 reserved
A
1 floor setting
A
2 floor displaying
H0 logic of the IO
control board
H1 logic of the car
control board
H2 front door
stopping floor
H3 rear door stopping
【F0 function setting】
00 High/low voltage
detection
01 Hand door enabling
02 Closing output delay
03 Fire safety mode
04 Closing output condition
of dual doors
05 Floor opening mode of
parallel outside calling
06 Reset mode of running
fault overtime
07 MF definition of IND
08 Internal command limit
times
09 Dual door control mode
10 Output landing of fire
forced landing
11 Floor internal command
opening enabling
12 LIN1 multi-function
definition
13 LIN2 multi-function
definition
14 LIN3 multi-function
definition
15 MF output in the car

INVT EC160 Specifications

General

Brand	INVT
Model	EC160
Category	Control Systems
Language	English