User manual of EC160 elevator intelligent integrated machine Product overview
20
No. Code Meaning Instruction
8 ER Elevator error Flash when elevator error
The LED displaying is defaulted as the current floor when there is no fault, while fault occurs, Er is
flashing and LED will report the fault code directly, such as and flashing. Press UP key to
watch the previous fault and the fault code will flash; press UP key to watch the next fault. Press
DOWN key to reset from the fault record and enter into the floor displaying. In the maintenance state,
if the elevator is in the bottom floor, dialing the maintenance switch for three times in 5 seconds will
clear the fault record.
3.7 Running environment
3.7.1 Temperature&humidity
Environment temperature range: -10°C~+40°C. Derate 4% for every additional 1°C if ambient
temperature exceeds 40°C. The highest temperature is 50°C.
Humidity≤90% RH. No condensation is allowed.
3.7.2 Altitude
The machine can output the rated power when installed with altitude of lower than 1000m. It will be
derated when the altitude is higher than 1000m. For details, please refer to the following figure:
Figure 3-2 Rating curve
3.7.3 Other environmental requirements
The inverter can not bear fierce impact or shock. So the oscillation range should be less than
5.88m/s
2
(0.6g).
The inverter should keep away from the electromagnetic radiation source.
The inverter should keep away from metal powder, dust, oil and water.
The inverter should keep away from direct sunlight, oil mist, steam and salt.
To Next Page
Loading...
Need help?
General
