Mitsubishi MELSEC Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE OPERATION
5.3 Settings and Procedures before Operation
5 - 11
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
SETTING AND PROCEDURES
6
I/O NUMBER ASSIGNMENT
7
MEMORIES AND FILES
8
INSTALLING / UNINSTALLING
5.3 Settings and Procedures before Operation
The following provides schematic procedures for operation.
(1) Starting up the C Controller module
POINT
If connection cannot be made to the C Controller module although "192.168.3.3
(default)" was set in the connection target setting, check the network settings on
the development environment (personal computer) side. (
Section 5.6)
Figure 5.7 Configuration at startup
Figure 5.8 Flowchart for C Controller module startup
Install
Development
environment (PC)
Module setting/monitoring
tool for C Controller module
(SW PVC-CCPU)
IP address [192.168.3. ]
Subnet mask [255.255.255.0]
IP address [192.168.3.3]
Subnet mask [255.255.255.0]
Factory-set values
Ethernet (Crossing cable)
C Controller module
Procedures for operation
Install SW PVC-CCPU and Tornado onto the development environment
(personal computer).
Mount the battery into the C Controller module.
Mount the C Controller module and other modules (input, output, and/or
intelligent function modules, etc.) on the base unit.
Connect the C Controller module to the development environment
(personal computer) one-to-one by a crossing cable, and start the C
Controller setting utility.
In the Connection target setting, select "192.168.3.3 (default IP)" to
connection the development environment (personal computer) to the C
Controller module.
Make parameter settings for a desired system configuration.
When configuring a single CPU system
When configuring a multiple CPU system
When configuring a CC-Link system
When configuring a MELSECNET/H system
When making microcomputer connection with GOT
Operation
Click Detail on the <<Online operation>> tab of the C Controller setting
utility, and set the C Controller module clock on the <<Clock>> tab.
Tornado Manual
Section 5.7.2
Chapter 8
Section 5.7.2
Section 2.2
Section 5.6
Section 5.6
Section 9.2.6
Section 9.1.3
Section 5.3 (2)
Section 17.1
Section 5.3 (3)
Section 5.3 (4)
Section 5.3 (5)

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English