Mitsubishi MELSEC Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE OPERATION
5.3 Settings and Procedures before Operation
5 - 15
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
SETTING AND PROCEDURES
6
I/O NUMBER ASSIGNMENT
7
MEMORIES AND FILES
8
INSTALLING / UNINSTALLING
(4) When configuring a MELSECNET/H system
* 1 To write the parameters, connect the utility to the C Controller module with the write authority.
( Section 5.11, Section 9.1.3)
Figure 5.13 MELSECNET/H system configuration
Figure 5.14 Flowchart for MELSECNET/H system configuration
C Controller module
Development environment (PC)
Ethernet
MELSECNET/H
Procedures for operation
Start up the C Controller module.
Set parameters, referring to (2) for a single CPU system,
or the flowchart in Section 17.1 for a multiple CPU system.
Start the MELSECNET/H utility, make connection target
setting, and connect the development environment
(personal computer) to the C Controller module.
1)
On the Module information screen, verify the list of
MELSECNET/H modules controlled by the C Controller
module.
In the Parameter setting of the MELSECNET/H utility, set
the MELSECNET/H module parameters.
Is the access target system a
multiple CPU system?
Set the logical station No. on the <<Target setting>> tab
of the MELSECNET/H utility.
No
Yes
No
Yes
Is the system a single CPU system?
Write the set parameters from the <<Online operation>>
tab of the MELSECNET/H utility to the C Controller
module.
Reset the C Controller module with the RESET/SELECT
switch. (Resetting the module makes the written
parameters effective.)
(To 2) on next page)
(To 3) on next page)
This section (2) or
Section 16.1
*1
Section 9.1.3
Section 9.4.2
Section 9.4.6
Section 9.4.7
Section 9.4.5
Section 5.4 (3)
This section (1)
This section (2) or
Section 17.1

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English