Mitsubishi MELSEC Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE OPERATION
5.3 Settings and Procedures before Operation
5 - 17
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
SETTING AND PROCEDURES
6
I/O NUMBER ASSIGNMENT
7
MEMORIES AND FILES
8
INSTALLING / UNINSTALLING
(5) When making microcomputer connection with GOT
POINT
Refer to the following manual for the commands that can be used for data
transmission to the GOT in microcomputer connection.
GOT Manual
Figure 5.15 Configuration of microcomputer connection with GOT
Figure 5.16 Flowchart for microcomputer connection with GOT
C Controller module
Development environment (PC)
Ethernet
RS-232
GOT
Procedures for operation
Start up the C Controller module.
Set parameters, referring to (2) for a single CPU
system, or the flowchart in Section 17.1 for a multiple
CPU system.
Operation
Create and debug a user program using Tornado, and
register it to the C Controller module.
Connect the GOT to CH2 (RS-232 interface) of the C
Controller module by a cable.
On the GOT, make various settings and create screen
programs.
GOT Manual
This section (2) or
Section 16.1
GOT Manual
This section (1)
Chapter 10
This section (2) or
Section 17.1

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English