Mitsubishi MELSEC Q Series User Manual

9 - 28
9.2 C Controller Setting Utility
9.2.5 Operating Module monitor screen
9
UTILITY OPERATION
(2) Module monitor screen
The input (X), output (Y) and buffer memory statuses of the module installed to the
selected slot are monitored on this tab.
Also the forced output of the output (Y) and forced write to the buffer memory can be
executed.
* 1 The slot No. cannot be changed during monitoring.
Change it after stopping monitoring.
(To next page)
Figure 9.29 Module monitor screen
Table9.13 Explanation of Module monitor screen
Item Description
Reference
section
Slot No.
*1
Set the slot No. to be monitored.
In a multiple CPU system configuration, setting slot No. of a CPU module
installed allows monitoring of the CPU shared memory.
"CPU" can be set only in a multiple CPU system configuration.
(Initial value: 0, Setting range: "CPU", 0 to 63)
Start I/O No.
Displays the start I/O No. of the module installed to the slot set in "Slot
No.".
Control CPU
Displays the CPU No. that controls the module installed to the slot set in
"Slot No.".
Displays " " (blank) if the slot where a CPU module is installed or to which
"CPU (Empty)" is set in I/O assignment is specified in "Slot No."
(When the C Controller module, to which the C Controller setting utility is
connected, is a control CPU, "*" is displayed on the right side of the CPU
No. indication.)
1)
2)
3)
Module information Event history SRAM monitor
Module monitor
Online operation

Mitsubishi MELSEC Q Series Specifications

General

Brand	Mitsubishi
Model	MELSEC Q Series
Category	Controller
Language	English