RL78/G1H CHAPTER 7 TIMER ARRAY UNIT
R01UH0575EJ0120 Rev. 1.20 Page 190 of 920
Dec 22, 2016
7.6.4 Collective manipulation of TOmn bit
In timer output register m (TOm), the setting bits for all the channels are located in one register in the same way
as timer channel start register m (TSm). Therefore, the TOmn bit of all the channels can be manipulated
collectively.
Only the desired bits can also be manipulated by enabling writing only to the TOmn bits (TOEmn = 0) that
correspond to the relevant bits of the channel used to perform output (TOmn).
TOmn (channel output) to which TOEmn = 1 is set is not affected by the write operation. Even if the write
operation is done to the TOmn bit, it is ignored and the output change by timer operation is normally done.
Remark m: Unit number (m = 0), n: Channel number (n = 3)
To Next Page
Loading...
Need help?
General
