Fax Communication Features
D418 178 SM
In this case, this feature destination e-mail address (gts@ricoh.co.jp) is read as the SMTP
server address "gts.abcd.com", and the transmissions bypass the SMTP server.
Selectable Options
These options are available for selection:
With the default settings, the scan resolution can be either standard or detail. Inch-mm
conversion before TX depends on IFAX SW01 Bit 7. Detail resolution will be used if
Super Fine resolution is selected, unless Fine resolution is enabled with IFAX SW01.
The requirements for originals (document size, scan width, and memory capacity) are
the same as for G3 fax memory TX.
The default compression is TIFF-F format.
IFAX SW00: Acceptable paper widths for sending
IFAX SW09: Maximum number of attempts to the same destination
Secure Internet Transmission
SMTP Authentication:
User Tools> System Settings> File Transfer> SMTP Authentication
POP Before SMTP:
User Tools> System Settings> File Transfer> POP Before SMTP
Mail Reception
Three Types
This machine supports three types of e-mail reception:
POP3 (Post Office Protocol Ver. 3.)
IMAP4 (Internet Messaging Access Protocol)
SMTP (Simple Mail Transfer Protocol)
For details: Core Technology Manual – Facsimile Processes – Faxing from a PC –
Internet/LAN Fax Boards – Mail Reception
POP3/IMAP4 Mail Reception Procedure
The machine automatically picks up e-mail from the server at an interval which is
adjustable in the range 2 to 1440 min. in 1-minute steps:
User Tools> System Settings> File Transfer> E-mail Reception Interval
SMTP Reception
1. The IFAX must be registered as an SMTP server in the MX record of the DNS server,
and the address of the received mail must specify the IFAX.
2. To enable SMTP reception: User Tools> System Settings> File Transfer> Reception
Protocol
To Next Page
Loading...
Need help?
General
