DETAILS
B513/B531 42 SM
6.10 JAM CONDITIONS
1. The entrance sensor does not turn on when the copier has fed paper 426 mm
after the copier exit sensor turned off.
2. The entrance sensor does not turn off when the upper transport motor has fed
paper 1.5 times the paper’s length after it turned on.
3. The upper tray exit sensor does not turn on when the upper transport motor
has fed paper 574 mm after the entrance sensor turned on.
4. The upper tray exit sensor does not turn off when the upper transport motor
has fed paper 1.5 times the paper’s length after it turned on.
5. In sort/stack mode, the shift tray exit sensor does not turn on when the upper
transport motor has fed paper 733 mm after the entrance sensor turned on.
6. In sort/stack mode, the shift tray exit sensor does not turn off when the upper
transport motor has fed paper 1.5 times the paper’s length after it turned on.
7. In staple mode, the stapler tray entrance sensor does not turn on when the
upper and lower transport motor have fed paper 835 mm after the entrance
sensor turned on.
8. In staple mode, the stapler tray entrance sensor does not turn off when the
upper transport motor has fed paper 1.5 times the paper’s length after it turned
on.
9. In staple mode, the stapler tray paper sensor does not turn off within 250
pulses of the stack feed-out motor after it started.
10. In staple mode, the shift tray exit sensor does not turn off within 1,260 ms after
the stack feed-out motor started.
To Next Page
Loading...
Need help?
General
