3、INTAKE SYSTEM COMPONENT 18
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 4134200-002000
ZT3
10－R Air filter element（carton packaging）
Fig.3 INTAKE SYSTEM
COMPONENT
Replace air filter element
PROCEDURE:
●Air filter element
If you need to maintain the air filter element, first remove the cushion, right side cover and so on. Remove two
standard parts① on the air filter with the tool, remove the box cover②
and then pull off the air filter element. Use
a blow gun to blow from the dusty side of the filter element and blow off the dust on the surface of the filter
element. If the blow is reversed, the dust cannot be cleaned, which may cause engine damage or increased intake
resistance, which may affect the driving experience. If there is any damage, please log in to Shengshi official
website to purchase additional parts after sale. Make sure the assembly is in place during assembly.
●Oil accumulation pipe and water supply pipe
When flushing the motorcycle, avoid water entering the inside of the air filter; a small amount of water can be
removed and the accumulated oil pipe (3) and water pipe (4) can be removed. Make sure that there is no water
inside to start the engine. The oil storage pipe should be inspected regularly. If the accumulated oil is more, it
should be released in time.
CAUTION:
●Regularly check whether the filter element of the carbon tank and air filter is not ventilated, otherwise it may
cause the oil supply to affect the driving experience.
●When blowing dust, pay attention to maintain a certain distance to avoid excessive damage to the filter
element.
To Next Page
Loading...
Need help?
General
