DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
config time
Purpose To manually configure system time and date settings.
Syntax
config time <date ddmthyyyy> <time hh:mm:ss>
Description
The config time date command configures the system time and
date settings. These will be overridden if SNTP is configured and
enabled.
Parameters
<date ddmthyyyy> –Specifies the date, using two numerical
characters for the day of the month, English abbreviation for the
name of the month, and four numerical characters for the year. For
example: 19jan2011.
<time hh:mm:ss> – Specifies the system time, using the format
hh:mm:ss; that is, two numerical characters each for the hour using
a 24-hour clock, the minute and second. For example: 19:42:30.
Restrictions Only administrator-level users can issue this command.
Example usage:
To manually set system time and date settings:
DGS-1100-24P/ME:admin#config time 09jan2012 15:50:50
Command : config time 09jan2012 15:50:50
Success.
DGS-1100-24P/ME:admin#
Purpose To determine the time zone used in order to adjust the system clock.
Syntax
config time_zone operator [+ | - ] hour <hour 0-13> minute
<minute 0-59>
Description
The config time_zone operator command adjusts the system clock
settings according to the time zone. Time zone settings adjust SNTP
information accordingly.
Parameters
operator [ + | - ] – May be (+) to add or (-) to subtract time to adjust
for time zone relative to GMT.
hour <hour 0-13> – Specifies the number of hours difference from
GMT.
minute <minute 0-59> – Specifies the number of minutes added or
subtracted to adjust the time zone.
Restrictions Only administrator-level users can issue this command.
117
To Next Page
Loading...
Need help?
General
