D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
18
IGMP SNOOPING COMMANDS
The Switch supports IGMPv1-, IGMPv2-, and IGMPv3 awareness (excluded IGMPv3 source-filtering)
snooping.
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
enable igmp_snooping
disable igmp_snooping
show igmp_snooping [vlan_name <vlan_name 8> | vlanid<vidlist 1-4094> | all]
config igmp_snooping
[vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | all] {fast_leave [enable |
disable] | state [enable | disable]}(1)
config igmp_snooping
querier
[vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | all] state [enable | disable]
create igmp_snooping
static_group
[vlan_name<vlan_name 8> | vlanid < vidlist 1-4094> ] <ipaddr>
config igmp_snooping
static_group
[vlan_name <vlan_name 8> | vlanid < vidlist 1-4094> ] < ipaddr > [ add | delete]
<portlist>
delete igmp_snooping
static_group
[vlan_name<vlan_name 8> | vlanid < vidlist 1-4094> ] <ipaddr>
create igmp_snooping
multicast_vlan
<vlan_name 8> <vlanid 2-4094>
config igmp_snooping
multicast_vlan
<vlan_name 8> { action [add | delete] [member_port <portlist> | source_port
<portlist> | tag_member_port <portlist >] |state [enable | disable] |
replace_source_ip <ipaddr> } (1)
delete igmp_snooping
multicast_vlan
[name <vlan_name 8>| all]
config igmp_snooping
multicast_vlan_group
<vlan_name 8> [add | delete] ipv4_range <mcast_address_range>
enable igmp_snooping
multicast_vlan
disable igmp_snooping
multicast_vlan
show igmp_snooping
multicast_vlan
{name <vlan_name 8>}
show igmp_snooping
multicast_vlan_group
{name <vlan_name 8>}
show igmp_snooping
group
[all | [vlan_name <vlan_name 8> | vlanid <vidlist 1-4094> | ports <portlist>]
{ipaddress<ipaddr>}]
89

D-Link DGS-1100-16/ME Specifications

General

Brand	D-Link
Model	DGS-1100-16/ME
Category	Switch
Language	English