DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Example usage:
To configure daylight savings time on the Switch to run from the 2
nd
April at 3 PM until the 2
nd
October at 3:30 PM and add
30 minutes at the onset of DST:
DGS-1100-24P/ME:admin#config dst annual s_date 2 s_mth 4 s_time 15:00
e_date 2 e_mth 10 e_time 15:30 offset 30
Command : config dst annual s_date 2 s_mth 4 s_time 15:00
10 e_time 15:30 offset 30
Success.
DGS-1100-24P/ME:admin#
show time
Purpose To display the current time settings and status.
Syntax
show time
Description
The show time command displays the system time and date
configuration, as well as displays the current system time.
Parameters None.
Restrictions None.
Example usage:
To show the time currently set on the Switch’s System clock:
DGS-1100-24P/ME:admin#show time
Command : show time
System Uptime : 3 hours, 14 minutes, 56 seconds
Current Time Source : System Clock
Current Time : 2000/01/01 03:14:56
Time Zone : GMT + 00:00
Daylight Saving Time : Enabled
Offset in Minutes : 30
From : 02 Apr 2009 15:00
To : 02 Oct 2010 15:30
DGS-1100-24P/ME:admin#
119
To Next Page
Loading...
Need help?
General