D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
27
D-LINK DISCOVERY PROTOCOL COMMANDS
The D-link Discovery Protocol (DDP) commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command Parameter
enable ddp
disable ddp
config ddp report_time [30 | 60 | 90 | 120 | never]
show ddp
Each command is listed in detail, as follows:
enable ddp
Purpose To enable DDP support of the switch.
Syntax
enable ddp
Description
The enable ddp command enables DDP support of the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable DDP support
DGS-1100-24P/ME:admin#enable ddp
Command : enable ddp
Success.
DGS-1100-24P/ME:admin#
disable ddp
Purpose To disable DDP support of the switch.
Syntax
disable ddp
Description
The disable ddp command disables DDP support of the switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
137

D-Link DGS-1100-16/ME Specifications

General

Brand	D-Link
Model	DGS-1100-16/ME
Category	Switch
Language	English