DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Example usage:
To configure the PoE port:
DGS-1100-24P/ME:admin#config poe ports portlist 1-
priority high
Command : config poe ports portlist 1-4 state enable priority high
Success.
DGS-1100-24P/ME:admin#
show poe system
Purpose This command is used to display the settings and actual values of
the whole PoE system.
Syntax
show poe system
Description This command is used to display the settings and actual values of
the whole PoE system.
Parameters None.
Restrictions None.
Example usage:
To show PoE system information:
DGS-1100-24P/ME:admin#show poe system
Command: show poe system
PoE System Information
------------------------------------
Delivered (W) : 6553.5(W)
Power Budget(W) : 100(W)
Trap State : Disabled
DGS-1100-24P/ME:admin#
Purpose This command is used to display the settings and actual values of
the PoE port.
Syntax
show poe ports { port_list <portlist>}
Description Displays the settings and actual values of the PoE port.
Note: For the PoE Status table, if the classification was shown
as “Legacy PD”, it will be classified to non-AF PD or Legacy PD.
Parameters
port_list <portlist> - Specifies a list of ports to be displayed.
Restrictions None.
142
To Next Page
Loading...
Need help?
General