D-Link DGS-1100-16/ME

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
22
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable lldp
disable lldp
show lldp
show lldp remote_ports
config lldp notification [enable | disable]
Each command is listed in detail, as follows:
enable lldp
Purpose To enable LLDP on the switch.
Syntax
enable lldp
Description
The enable lldp command enables the Link Layer Discovery
Protocol (LLDP) on the switch.
Parameters
None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable LLDP on the switch:
DGS-1100-24P/ME:admin#enable lldp
Command: enable lldp
Success.
DGS-1100-24P/ME:admin#
disable lldp
Purpose To disable LLDP on the switch.
Syntax
disable lldp
Description
The disable lldp command disables the Link Layer Discovery
Protocol (LLDP) on the switch.
Parameters None.
123