DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
PORT MIRRORING COMMANDS
The Port Mirroring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
enable mirror
disable mirror
config mirror
target <port> source ports <portlist> [both | rx | tx]
show mirror
Each command is listed in detail, as follows:
enable mirror
Purpose Used to enable a previously entered port mirroring configuration.
Syntax
enable mirror
Description
The enable mirror
command, combined with the disable mirror
command below, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
off without having to modify the port mirroring configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the mirroring feature:
DGS-1100-24P/ME:admin#enable mirror
Command : enable mirror
Success.
DGS-1100-24P/ME:admin#
disable mirror
Purpose Used to disable a previously entered port mirroring configuration.
Syntax
disable mirror
Description
The disable mirror command, combined with
the enable mirror
command above, allows the user to enter a port mirroring
configuration into the Switch, and then turn the port mirroring on and
To Next Page
Loading...
Need help?
General