remote host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages are to be sent to the
remote host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages are to be sent to the
remote host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages are to be sent to the
remote host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages are to be sent to the
remote host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages are to be sent to the
remote host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages are to be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that
the syslog protocol is to be used to send messages to the remote
host. The range of udp port number is 514, 1024-65535.
ipaddress <ipaddr> − Specifies the IPv4 address of the remote host
to which syslog messages are to be sent.
state [enable | disable] − Allows the sending of syslog messages to
the remote host, specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure a syslog host:
DGS-1100-24P/ME:admin#config syslog host severity all
Command : config syslog host severity all
Success.
show syslog host
Purpose To display the syslog hosts currently configured on the Switch.
Syntax
show syslog host
Description
The show syslog host command displays the syslog hosts that are
currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To show Syslog host information:
DGS-1100-18/ME:admin#show syslog host
Command : show syslog host
Syslog Global State : Enabled
58
To Next Page
Loading...
Need help?
General