D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Success.
DGS-1100-24P/ME:admin#
show snmp host
Purpose To display the recipient of SNMP traps generated by the Switch’s
SNMP agent.
Syntax
show snmp host
Description
The show snmp host command is used to display the IP addresses
and configuration information of remote SNMP managers that are
designated as recipients of SNMP traps generated by the Switch’s
SNMP agent.
Parameters None.
Restrictions None.
Example usage:
To display the currently configured SNMP hosts on the Switch:
DGS-1100-24P/ME:admin#show snmp host
Command : show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name
------------------------- ----------------------- ----------------
10.90.90.22 v2c private
Total Entries : 1
DGS-1100-24P/ME:admin#
enable snmp traps
Purpose To enable SNMP trap support.
Syntax
enable snmp traps
Description
The enable snmp traps command enables SNMP trap support on
the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SNMP trap support on the Switch:
DGS-1100-24P/ME:admin#enable snmp traps
Command : enable snmp traps
41

D-Link DGS-1100-16/ME Specifications

General

Brand	D-Link
Model	DGS-1100-16/ME
Category	Switch
Language	English