DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
config lacp_ports
Purpose To configure settings for LACP compliant ports.
Syntax
config lac
p_ports <portlist> m
ode [active | passive]
Description
The config lacp_ports command is used to configure ports that
have been previously designated as LACP ports.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
•
active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant devices
to negotiate the aggregated link so the group may be changed
dynamically as needs require. In order to utilize the ability to change
an aggregated port group, that is, to add or subtract ports from the
group, at least one of the participating devices must designate LACP
ports as active. Both devices must support LACP.
•
passive – LACP ports that are designated as passive cannot
process LACP control frames. In order to allow the linked port group
to negotiate adjustments and make changes dynamically, at one end
of the connection must have “active” LACP ports (see above).
Restrictions Only administrator-level users can issue this command.
Example usage:
To display LACP information for port1~3:
DGS-1100-24P/ME:admin#config lacp_port 1-3 mode active
Command : config lacp_port 1-3 mode active
Success.
DGS-1100-24P/ME:admin#
165
To Next Page
Loading...
Need help?
General