D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
eth10 SP
Total Entries: 1
DGS-1100-24P/ME:admin#
config 802.1p default_priority
Purpose To specify default priority handling of untagged packets received by
the Switch.
Syntax
config
scheduling {ports <portlist>} [ Low | Medium | High |
Highest]
Description
The configure 802.1p default_priority
command allows you to
specify default priority handling of untagged packets received by the
Switch. The priority value entered with this command will be used to
determine the hardware priority queues that the packet will be
forwarded to.
Parameters
ports<portlist> – A port or range of ports to be configured.
Low – Set the priority to low mode.
Medium – Set the priority to medium mode.
High – Set the priority to high mode.
Highest – Set the priority to highest mode.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the 802.1p default_priority:
DGS-1100-24P/ME:admin#config 802.1p default_priority ports 3-4 Low
Command : config 802.1p default_priority ports 3-4 Low
Success.
DGS-1100-24P/ME:admin#
show 802.1p default_priority
Purpose To display the setting of 802.1p default_priority.
Syntax
show 802.1p default_priority {ports <portlist>}
Description
The show 802.1p default_priority command displays the current
configured default priority settings on the switch.
Parameters
ports<portlist> – A port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the 802.1p default_priority:
DGS-1100-24P/ME:admin#show 802.1p default_priority ports 1-4
73

D-Link DGS-1100-16/ME Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
Layer	Layer 2
MAC Address Table	8K
Dimensions	440 x 180 x 44 mm
Switch Type	Managed
Humidity	5% to 95% non-condensing
Jumbo Frame Support	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Certifications	CE, FCC

Summary

COMMAND SYNTAX

BASIC SWITCH COMMANDS

User Management and System Configuration

Covers commands for managing user accounts, saving settings, rebooting, and system prompts.

SWITCH PORT COMMANDS

Port Configuration and Status

Details commands for configuring port settings like speed, duplex, and showing port status.

VLAN COMMANDS

VLAN Management

Commands for creating, deleting, and configuring VLANs and port assignments.

IGMP SNOOPING COMMANDS

IGMP Snooping Configuration

Commands to enable, disable, and configure IGMP snooping for VLANs and groups.

MLD SNOOPING COMMANDS

MLD Snooping Configuration

TIME AND SNTP COMMANDS

Time and SNTP Configuration

LLDP COMMANDS

SPANNING TREE PROTOCOL COMMANDS

STP Configuration and Settings

POE COMMANDS

PoE System and Port Configuration