D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
DGS-1100-24P/ME:admin#delete time_range dlink
Command : delete time_range dlink
Success.
DGS-1100-24P/ME:admin#
show time_range
Purpose To display the currently configured access profiles on the Switch.
Syntax
show time_range
Description
The show time_range command displays the time range
configuration.
Parameters None.
Restrictions None.
Example usage:
To display time range settings on the Switch:
DGS-1100-24P/ME:admin#show time_range
Time Range Information
------------------------------------------
Range Name : dlink
Weekdays : Daily
Start Time : 10:10:00
End Time : 12:10:00
Total Entries :1
DGS-1100-24P/ME:admin#
config telnet auto_logout
Purpose To configure the auto log out time on the Switch.
Syntax
config telnet auto_logout [2_minutes | 5_minutes | 10_minutes |
15_minutes]
Description This command is used to configure the auto logout time for idle
connections.
Parameters
2_minutes - Two minutes to set the automatic logout time
5_minutes - Five minutes to set the automatic logout time
10_minutes - Ten minutes to set the automatic logout time
15_minutes - Fifteen minutes to set the automatic logout time
Restrictions Only administrator-level users can issue this command.
Example usage:
Two minutes to set the automatic logout time:
DGS-1100-24P/ME:admin#config telnet auto_logout 2_minutes
Command : config telnet auto_logout 2_minutes
28

D-Link DGS-1100-16/ME Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
Layer	Layer 2
MAC Address Table	8K
Dimensions	440 x 180 x 44 mm
Switch Type	Managed
Humidity	5% to 95% non-condensing
Jumbo Frame Support	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Certifications	CE, FCC

Summary

COMMAND SYNTAX

BASIC SWITCH COMMANDS

User Management and System Configuration

Covers commands for managing user accounts, saving settings, rebooting, and system prompts.

SWITCH PORT COMMANDS

Port Configuration and Status

Details commands for configuring port settings like speed, duplex, and showing port status.

VLAN COMMANDS

VLAN Management

Commands for creating, deleting, and configuring VLANs and port assignments.

IGMP SNOOPING COMMANDS

IGMP Snooping Configuration

Commands to enable, disable, and configure IGMP snooping for VLANs and groups.

MLD SNOOPING COMMANDS

MLD Snooping Configuration

TIME AND SNTP COMMANDS

Time and SNTP Configuration

LLDP COMMANDS

SPANNING TREE PROTOCOL COMMANDS

STP Configuration and Settings

POE COMMANDS

PoE System and Port Configuration