D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
22 Disabled
23 Disabled
24 Disabled
DGS-1100-24P/ME:admin#
save
Purpose To save changes in the Switch’s configuration to non-volatile RAM.
Syntax
save
Description
The save command used to enter the current switch configuration
into non-volatile RAM. The saved switch configuration will be loaded
into the Switch’s memory each time the Switch is restarted.
Parameters None
Restrictions Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM:
DGS-1100-24P/ME:admin#save
Command : save
Success.
DGS-1100-24P/ME:admin#
reboot
Purpose To reboot the Switch.
Syntax
reboot {force_agree}
Description
The reboot command restarts the Switch.
Parameters
force_agree –When force_agree is specified, the reboot command
will be executed immediately without further confirmation.
Restrictions Only administrator-level users can issue this command.
Example usage:
To restart the Switch:
DGS-1100-24P/ME:admin#reboot
Command : reboot
Are you sure you want to proceed with the system reboot?(y/n) y
Please wait, the switch is rebooting...
24

D-Link DGS-1100-16/ME Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
Layer	Layer 2
MAC Address Table	8K
Dimensions	440 x 180 x 44 mm
Switch Type	Managed
Humidity	5% to 95% non-condensing
Jumbo Frame Support	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Certifications	CE, FCC

Summary

COMMAND SYNTAX

BASIC SWITCH COMMANDS

User Management and System Configuration

Covers commands for managing user accounts, saving settings, rebooting, and system prompts.

SWITCH PORT COMMANDS

Port Configuration and Status

Details commands for configuring port settings like speed, duplex, and showing port status.

VLAN COMMANDS

VLAN Management

Commands for creating, deleting, and configuring VLANs and port assignments.

IGMP SNOOPING COMMANDS

IGMP Snooping Configuration

Commands to enable, disable, and configure IGMP snooping for VLANs and groups.

MLD SNOOPING COMMANDS

MLD Snooping Configuration

TIME AND SNTP COMMANDS

Time and SNTP Configuration

LLDP COMMANDS

SPANNING TREE PROTOCOL COMMANDS

STP Configuration and Settings

POE COMMANDS

PoE System and Port Configuration