D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
DGS-1100-24P/ME:admin#
config snmp coldstart_traps
Purpose To configure SNMP cold start trap support.
Syntax
config snmp coldstart_traps [enable | disable]
Description
The config snmp coldstart_traps command configures SNMP cold
start trap support on the Switch.
Parameters
[enable | disable] – Set the trap support state of the switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To turn on SNMP cold start trap support:
DGS-1100-24P/ME:admin#config snmp coldstart_traps enable
Command : config snmp coldstart _traps enable
Success.
DGS-1100-24P/ME:admin#
config snmp warmstart_traps
Purpose To configure SNMP warm start trap support.
Syntax
config snmp warmstart_traps [enable | disable]
Description
The config snmp warmstart_traps command configures SNMP
warm start trap support on the Switch.
Parameters
[enable | disable] – Set the trap support state of the switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To turn on SNMP warm start trap support:
DGS-1100-24P/ME:admin#config snmp warmstart_traps enable
Command : config snmp warmstart_traps enable
Success.
DGS-1100-24P/ME:admin#
enable snmp
Purpose To enable SNMP support.
Syntax
enable snmp
Description
The enable snmp command enables SNMP support on the Switch.
46

D-Link DGS-1100-16/ME Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
Layer	Layer 2
MAC Address Table	8K
Dimensions	440 x 180 x 44 mm
Switch Type	Managed
Humidity	5% to 95% non-condensing
Jumbo Frame Support	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Certifications	CE, FCC

Summary

COMMAND SYNTAX

BASIC SWITCH COMMANDS

User Management and System Configuration

Covers commands for managing user accounts, saving settings, rebooting, and system prompts.

SWITCH PORT COMMANDS

Port Configuration and Status

Details commands for configuring port settings like speed, duplex, and showing port status.

VLAN COMMANDS

VLAN Management

Commands for creating, deleting, and configuring VLANs and port assignments.

IGMP SNOOPING COMMANDS

IGMP Snooping Configuration

Commands to enable, disable, and configure IGMP snooping for VLANs and groups.

MLD SNOOPING COMMANDS

MLD Snooping Configuration

TIME AND SNTP COMMANDS

Time and SNTP Configuration

LLDP COMMANDS

SPANNING TREE PROTOCOL COMMANDS

STP Configuration and Settings

POE COMMANDS

PoE System and Port Configuration