D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
11
NETWORK MONITORING COMMANDS
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameter
show packet ports <portlist>
show error ports <portlist>
clear counters {ports <porlist>}
clear log
show log
{index <value_list> | severity [all | informational | warning ]}
enable syslog
disable syslog
show syslog
config syslog host
[severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 |
local4 | local5 | local6 | local7] | state [enable | disable] | udp_port
<udp_port_number> | ipaddress <ipaddr>]
show syslog host
cable diagnostic [port <portlist> | all]
Each command is listed in detail, as follows:
show packet ports
Purpose To display statistics about the packets sent and received in frames
per second by the Switch.
Syntax
show packet ports <portlist>
Description
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of
frame associated with these packets.
Parameters
<portlist> − A port or range of ports whose statistics are to be
displayed.
Restrictions None.
Example usage:
To display the packets analysis for port 5:
52

D-Link DGS-1100-16/ME Specifications

General

Ports	16 x 10/100/1000BASE-T
Switching Capacity	32 Gbps
Forwarding Rate	23.8 Mpps
Layer	Layer 2
MAC Address Table	8K
Dimensions	440 x 180 x 44 mm
Switch Type	Managed
Humidity	5% to 95% non-condensing
Jumbo Frame Support	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Certifications	CE, FCC

Summary

COMMAND SYNTAX

BASIC SWITCH COMMANDS

User Management and System Configuration

Covers commands for managing user accounts, saving settings, rebooting, and system prompts.

SWITCH PORT COMMANDS

Port Configuration and Status

Details commands for configuring port settings like speed, duplex, and showing port status.

VLAN COMMANDS

VLAN Management

Commands for creating, deleting, and configuring VLANs and port assignments.

IGMP SNOOPING COMMANDS

IGMP Snooping Configuration

Commands to enable, disable, and configure IGMP snooping for VLANs and groups.

MLD SNOOPING COMMANDS

MLD Snooping Configuration

TIME AND SNTP COMMANDS

Time and SNTP Configuration

LLDP COMMANDS

SPANNING TREE PROTOCOL COMMANDS

STP Configuration and Settings

POE COMMANDS

PoE System and Port Configuration