D-Link DGS-1100-16/ME User Manual

DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Success
DGS-1100-24P/ME:admin#
show telnet
Purpose To display information about auto-logout time on the Switch.
Syntax
show telnet
Description
The show telnet command displays auto-logout time on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the auto-logout time information:
DGS-1100-24P/ME:admin#show telnet
Command : show telnet
Auto-Logout : 5 mins
DGS-1100-24P/ME:admin#
config firmware
Purpose To configure the firmware image boot up.
Syntax
config firmware image <1,2> boot_up.
Description This command is used to configure the firmware image boot up.
Parameters
<1,2> - Image firmware 1 or firmware 2 for boot up.
Restrictions Only administrator-level users can issue this command.
Example usage:
Two minutes to set the automatic logout time:
DGS-1100-24P/ME:admin#config config firmware image 1 boot_up
Command : config firmware image 1 boot_up
Success.
DGS-1100-24P/ME:admin#
show firmware
Purpose Used to display the firmware section information.
Syntax
show firmware information
29

D-Link DGS-1100-16/ME Specifications

General

Brand	D-Link
Model	DGS-1100-16/ME
Category	Switch
Language	English