EEE
The EEE commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
config eee
[portlist <portlist> | all] state [enable | disable]
show eee {portlist <portlist>}
Each command is listed in detail, as follows:
config eee
Purpose Used to configure eee function on the switch.
Syntax
config eee [portlist <portlist> | all] state [enable | disable]
Description
The config eee command is used to enable/disable the eee function
on special port(s) on the switch.
Note: The EEE feature is only supported on the copper ports on all
DGS-1100/ME Series switches.
Parameters
portlist <portlist> - Specified a range of ports to be configured.
(UnitID: port number).
all - For set all ports in the system, you may use “all” parameter.
state - Specified the eee state. The default state is disabled.
enable: Enable the eee function on the special port.
disable: Disable the eee function on the special port.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable eee in port 3:
DGS-1100-24P/ME:config eee portlist 3 state enable
Command : config eee portlist 3 state enable
Success.
DGS-1100-24P/ME:admin#
166
To Next Page
Loading...
Need help?
General