Configuring the Switch
3-68
3
• Quiet Period – Sets the time that a switch port waits after the Max Request count
has been exceeded before attempting to acquire a new client. (Range: 1-65535
seconds; Default: 60 seconds)
• Re-authentication Period – Sets the time period after which a connected client
must be re-authenticated. (Range: 1-65535 seconds; Default: 3600 seconds)
• TX Period – Sets the time period during an authentication session that the switch
waits before re-transmitting an EAP packet. (Range: 1-65535; Default: 30 seconds)
• Authorized –
- Yes – Connected client is authorized.
- No – Connected client is not authorized.
- Blank – Displays nothing when dot1x is disabled on a port.
• Supplicant – Indicates the MAC address of a connected client.
• Trunk – Indicates if the port is configured as a trunk port.
Web – Click Security, 802.1x, Port Configuration. Modify the parameters required,
and click Apply.
Figure 3-43. 802.1x Port Configuration
To Next Page
Loading...
Need help?
General