Command Line Interface
4-134
4
Example
Related Commands
queue cos-map (4-214)
show map access-list mac (4-134)
show map access-list mac
This command shows the CoS value mapped to a MAC ACL for the current
interface. (The CoS value determines the output queue for packets matching an
ACL rule.)
Syntax
show map access-list mac [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Example
Related Commands
map access-list mac (4-133)
match access-list mac
This command changes the IEEE 802.1p priority of a Layer 2 frame matching the
defined ACL rule. (This feature is commonly referred to as ACL packet marking.)
Use the no form to remove the ACL marker.
Syntax
match access-list mac acl_name set priority priority
no match access-list mac acl_name
• acl_name – Name of the ACL. (Maximum length: 16 characters)
• priority – Class of Service value in the IEEE 802.1p priority tag.
(Range:
0-7; 7 is the highest priority)
Console(config)#int eth 1/5
Console(config-if)#map access-list mac M5 cos 0
Console(config-if)#
Console#show map access-list mac
Access-list to COS of Eth 1/5
Access-list M5 cos 0
Console#
To Next Page
Loading...
Need help?
General