Enterasys Matrix-V V2H124-24 User Manual

Configuring the Switch
3-32
3
CLI – Enter the IP address of at least one SMTP server, set the syslog severity level
to trigger an email message, and specify the switch (source) and up to five recipient
(destination) email addresses. Enable SMTP with the logging sendmail command
to complete the configuration. Use the show logging sendmail command to display
the current SMTP configuration.
Resetting the System
Web – Select System, Reset to reboot the switch. When prompted, confirm that you
want reset the switch.
Figure 3-19. Reseting the Switch
CLI – Use the reload command to reboot the system.
Note: When restarting the system, it always runs the Power-On Self-Test.
Console(config)#logging sendmail host 192.168.1.4 4-50
Console(config)#logging sendmail level 3 4-51
Console(config)#logging sendmail source-email
Matrix-V-Series@Enterasys.com 4-52
Console(config)#logging sendmail destination-email
someone@Enterasys.com 4-52
Console(config)#logging sendmail 4-53
Console(config)#exit
Console#show logging sendmail 4-53
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. someone@Enterasys.com
SMTP source email address: Matrix-V-Series@Enterasys.com
SMTP status: Enabled
Console#
Console#reload 4-22
System will be restarted, continue <y/n>? y
Console#

Enterasys Matrix-V V2H124-24 Specifications

General

Brand	Enterasys
Model	Matrix-V V2H124-24
Category	Switch
Language	English