Command Line Interface
4-66
4
Flash/File Commands
These commands are used to manage the system code or configuration files.
copy
Use this command to move (upload/download) a code image or configuration file
between the switch’s flash memory and a TFTP server. When you save the system
code or configuration settings to a file on a TFTP server, that file can later be
downloaded to the switch to restore system operation. The success of the file
transfer depends on the accessibility of the TFTP server and the quality of the
network connection.
Syntax
copy file {controller | file | running-config | startup-config | tftp | unit}
copy running-config {file | startup-config | tftp}
copy startup-config {file | running-config | tftp}
copy tftp {file | running-config | startup-config | https-certificate |
public-key}
copy unit file
• controller - Allows you to download new PoE controller code files.
• file - Keyword that allows you to copy to/from a file.
• running-config - Keyword that allows you to copy to/from the current
running configuration.
• startup-config - The configuration used for system initialization.
• tftp - Keyword that allows you to copy to/from a TFTP server.
• unit - Keyword that allows you to copy to/from a specific unit in the stack.
• https-certificate - Copies an HTTPS certificate from an TFTP server to the
switch.
• public-key - Keyword that allows you to copy a SSH key from a TFTP
server.
Table 4-22. Flash/File Commands
Command Function Mode Page
copy Copies a code image or a switch configuration to or from
flash memory or a TFTP server
PE 4-66
delete Deletes a file or code image PE 4-69
dir Displays a list of files in flash memory PE 4-70
whichboot Displays the files booted PE 4-71
boot system Specifies the file or image used to start up the system GC 4-71
To Next Page
Loading...
Need help?
General