Command Line Interface
4-228
4
Example
The following shows the multicast entries learned through IGMP snooping for
VLAN
1:
IGMP Query Commands (Layer 2)
ip igmp snooping querier
Use this command to enable the switch as an IGMP querier. Use the no form to
disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.1.2.3 Eth1/11 IGMP
Console#
Table 4-71. IGMP Query Commands (Layer 2)
Command Function Mode Page
ip igmp snooping querier Allows this device to act as the querier for IGMP snooping GC 4-228
ip igmp snooping
query-count
Configures the query count GC 4-229
ip igmp snooping
query-interval
Configures the query interval GC 4-230
ip igmp snooping
query-max-response-time
Configures the report delay GC 4-230
ip igmp snooping
router-port-expire-time
Configures the query timeout GC 4-231
To Next Page
Loading...
Need help?
General