VLAN Commands
4-199
4
vlan database
Use this command to enter VLAN database mode. All commands in this mode will
take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, change, and delete VLANs.
After finishing configuration changes, you can display the VLAN settings by
entering the show vlan command.
•Use the interface vlan command mode to define the port membership mode
and add or remove ports from a VLAN. The results of these commands are
written to the running-configuration file, and you can display this file by
entering the show running-config command.
Example
Related Commands
show vlan (4-206)
vlan
Use this command to configure a VLAN. Use the no form to restore the default
settings or delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active | suspend}]
no vlan vlan-id [name | state]
• vlan-id - ID of configured VLAN. (Range: 1-4094, no leading zeroes)
• name - Keyword to be followed by the VLAN name.
• vlan-name - ASCII string from 1 to 32 characters.
• media ethernet - Ethernet media type.
• state - Keyword to be followed by the VLAN state.
• active - VLAN is operational.
• suspend - VLAN is suspended. Suspended VLANs do not pass packets.
Default Setting
By default only VLAN 1 exists and is active.
Console(config)#vlan database
Console(config-vlan)#
To Next Page
Loading...
Need help?
General