System Management Commands
4-51
4
Command Usage
• You can specify up to three SMTP servers for event handing. However, you
must enter a separate command to specify each server.
• To send email alerts, the switch first opens a connection, sends all the email
alerts waiting in the queue one by one, and finally closes the connection.
• To open a connection, the switch first selects the server that successfully
sent mail during the last connection, or the first server configured by this
command. If it fails to send mail, the switch selects the next server in the list
and tries to send mail again. If it still fails, the system will repeat the process
at a periodic interval. (A trap will be triggered if the switch cannot
successfully open a connection.)
Example
logging sendmail level
This command sets the severity threshold used to trigger alert messages.
Syntax
logging sendmail level level
level - One of the system message levels (page 4-45). Messages sent
include the selected level down to level 0. (Range: 0-7; Default: 7)
Default Setting
Level 7
Command Mode
Global Configuration
Command Usage
The specified level indicates an event threshold. All events at this level or
higher will be sent to the configured email recipients. (For example, using
Level 7 will report all events from level 7 to level 0.)
Example
This example will send email alerts for system errors from level 3 through 0.
Console(config)#logging sendmail host 192.168.1.19
Console(config)#
Console(config)#logging sendmail level 3
Console(config)#
To Next Page
Loading...
Need help?
General