Access Control List Commands
4-123
4
Related Commands
ip access-group (4-122)
map access-list ip
This command sets the output queue for packets matching an ACL rule. The
specified CoS value is only used to map the matching packet to an output queue; it
is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list ip acl_name cos cos-value
acl_name – Name of the ACL. (Maximum length: 16 characters)
cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
Command Usage
• You must configure an ACL mask before you can map CoS values to the
rule.
• A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown in the following table. For information on mapping
the CoS values to output queues, see queue cos-map on page 4-214.
Example
Related Commands
queue cos-map (4-214)
show map access-list ip (4-124)
Table 4-39. Mapping CoS Values to ACL Rules
Queue 0 1 2 3
Priority 1,2 0,3 4,5 6,7
Console(config)#interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#
To Next Page
Loading...
Need help?
General