IP Interface Commands
4-233
4
show ip igmp snooping mrouter
Use this command to display information on statically configured and dynamically
learned multicast router ports.
Syntax
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static or Dynamic.
Example
The following shows the ports in VLAN 1 which are attached to multicast routers:
IP Interface Commands
DHCP is enabled by default on this switch, with an IP address of 0.0.0.0. To set an
IP address you need to use the ip dhcp restart command, or manually enter an
address using the ip address command. You may also need to a establish a default
gateway between this device and the management stations.
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Port Type
---- ------------------- -------
1 Eth 1/11 Static
2 Eth 1/12 Dynamic
Console#
Table 4-73. IP Interface Command Syntax
Command Function Mode Page
ip address Sets the IP address for the current interface IC 4-234
ip default-gateway Defines the default gateway through which an in-band
management station can reach this device
GC 4-235
ip dhcp restart Submits a BOOTP or DCHP client request PE 4-235
show ip interface Displays the IP settings for this device PE 4-236
show ip redirects Displays the default gateway configured for this device PE 4-236
ping Sends ICMP echo request packets to another node on the
network
NE, PE 4-237
To Next Page
Loading...
Need help?
General