Command Line Interface
4-220
4
map ip dscp (Global Configuration)
Use this command to enable IP DSCP mapping (i.e., Differentiated Services Code
Point mapping). Use the no form to disable IP DSCP mapping.
Syntax
[no] map ip dscp
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
• IP Precedence and IP DSCP cannot both be enabled. Enabling one of these
priority types will automatically disable the other type.
Example
The following example shows how to enable IP DSCP mapping globally:
map ip dscp (Interface Configuration)
Use this command to set IP DSCP priority (i.e., Differentiated Services Code Point
priority). Use the no form to restore the default table.
Syntax
map ip dscp dscp-value cos cos-value
no map ip dscp
• dscp-value - 8-bit DSCP value. (Range: 0-255)
• cos-value - Class-of-Service value (Range: 0-7)
Console(config)#map ip dscp
Console(config)#
To Next Page
Loading...
Need help?
General