Multicast Filtering
3-173
3
Notes: 1. All systems on the subnet must support the same version.
2. Some attributes are only enabled for IGMPv2, including IGMP Report Delay
and IGMP Query Timeout.
Web – Click IGMP, IGMP Configuration. Adjust the IGMP settings as required, and
then click Apply. (The default settings are shown below.)
Figure 3-106. Configuring Internet Group Management Protocol
CLI – This example modifies the settings for multicast filtering, and then displays the
current status.
Console(config)#ip igmp snooping 4-225
Console(config)#ip igmp snooping querier 4-228
Console(config)#ip igmp snooping query-count 10 4-229
Console(config)#ip igmp snooping query-interval 100 4-230
Console(config)#ip igmp snooping query-max-response-time 20 4-230
Console(config)#ip igmp snooping query-time-out 300 4-231
Console(config)#ip igmp snooping version 2 4-226
Console(config)#exit
Console#show ip igmp snooping 4-227
Igmp Snooping Configuration
----------------------------------------------
Service status: Enabled
Querier status: Enabled
Query count: 10
Query interval: 100 sec
Query max response time: 20 sec
Query time-out: 300 sec
IGMP snooping version: Version 2
Console#
To Next Page
Loading...
Need help?
General