Enterasys Matrix-V V2H124-24 User Manual

Command Line Interface
4-100
4
dot1x system-auth-control
This command enables IEEE 802.1x globally for the switch. Use the no form to
disable 802.1x globally.
Syntax
[no] dot1x system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC 4-102
dot1x re-authenticate Forces re-authentication on specific ports PE 4-103
dot1x re-authentication Enables re-authentication for all ports IC 4-103
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting to
acquire a new client
IC 4-104
dot1x timeout re-authperiod Sets the time period after which a connected client must
be re-authenticated
IC 4-104
dot1x timeout tx-period Sets the time period during an authentication session that
the switch waits before re-transmitting an EAP packet
IC 4-105
show dot1x Shows all dot1x related information PE 4-105
system vlan-auth Enables VLAN authorization, enforcing modifications to
VLAN attributes for packets forwarded through the switch
GC 4-108
vlan-auth Applies information in the VLAN-Tunnel-Type field that is
returned from the authentication server to the selected port
IC 4-108
vlan-auth egress Controls the modification of the current VLAN egress list
(of the VLAN returned in the VLAN-Tunnel-Type, and
reported by etsysVlanAuthorizationVlanID) upon
successful authentication
IC 4-109
show system vlan-auth Shows the current VLAN authorization settings GC 4-110
Console(config)#dot1x system-auth-control
Console(config)#
Table 4-36. 802.1x Port Authentication Commands (Continued)
Command Function Mode Page

Enterasys Matrix-V V2H124-24 Specifications

General

Brand	Enterasys
Model	Matrix-V V2H124-24
Category	Switch
Language	English