GVRP and Bridge Extension Commands
4-209
4
show gvrp configuration
Use this command to show if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
- port-channel channel-id (Range: 1-6)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
garp timer
Use this command to set the values for the join, leave and leaveall timers. Use the
no form to restore the timers' default values.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
•{join | leave | leaveall} - Which timer to set.
- timer_value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leavall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
Gvrp configuration: Disabled
Console#
To Next Page
Loading...
Need help?
General