Interface Commands
4-157
4
• This command can enable or disable broadcast storm control for the
selected interface. However, the specified threshold value applies to all ports
on the switch.
Example
The following shows how to configure broadcast storm control at 600 packets per
second on port 5:
clear counters
Use this command to clear statistics on an interface.
Syntax
clear counters interface
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
- port-channel channel-id (Range: 1-6)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Statistics are only initialized for a power reset. This command sets the base
value for displayed statistics to zero for the current management session.
However, if you log out and back into the management interface, the statistics
displayed will show the absolute value accumulated since the last power reset.
Example
The following example clears statistics on Ethernet port 1/1
Console(config)#interface ethernet 1/5
Console(config-if)#switchport broadcast packet-rate 600
Console(config-if)#
Console#clear counters ethernet 1/1
Console#
To Next Page
Loading...
Need help?
General