Command Line Interface
4-104
4
Example
dot1x timeout quiet-period
This command sets the time that a switch port waits after the Max Request Count
has been exceeded before attempting to acquire a new client. Use the no form to
reset the default.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
dot1x timeout re-authperiod
This command sets the time period after which a connected client must be
re-authenticated.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface ethernet 1/5
Console(config-if)#dot1x re-authentication
Console(config-if)#
Console(config)#interface ethernet 1/24
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
Console(config)#interface ethernet 1/5
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
To Next Page
Loading...
Need help?
General