Enterasys Matrix-V V2H124-24 - Logging Sendmail Destination-Email; Logging Sendmail Source-Email

Command Line Interface
4-52
4
logging sendmail source-email
This command sets the email address used for the “From” field in alert messages.
Syntax
logging sendmail source-email email-address
email-address - The source email address used in alert messages.
(Range:
1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You may use a symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
Example
This example will send email alerts for system errors from level 3 through 0.
logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The recipient email address for alert messages.
(Range:
1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
Example
Console(config)#logging sendmail source-email anyone@enterasys.com
Console(config)#
Console(config)#logging sendmail destination-email ted@enterasys.com
Console(config)#