Command Line Interface
4-30
4
Web Server Commands
ip http port
Use this command to specify the TCP port number used by the Web browser
interface. Use the no form to use the default port.
Syntax
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser interface.
(Range:
1-65535)
Default Setting
80
Command Mode
Global Configuration
Example
Related Commands
ip http server (4-30)
ip http server
Use this command to allow this device to be monitored or configured from a
browser. Use the no form to disable this function.
Syntax
[no] ip http server
Default Setting
Enabled
Command Mode
Global Configuration
Table 4-11. Web Server Commands
Command Function Mode Page
ip http port Specifies the port to be used by the web browser interface GC 4-30
ip http server Allows the switch to be monitored or configured from a browser GC 4-30
ip http secure-server Enables HTTPS/SSL for encrypted communications GC 4-31
ip http secure-port Specifies the UDP port number for HTTPS/SSL GC 4-32
Console(config)#ip http port 769
Console(config)#
To Next Page
Loading...
Need help?
General