Basic Configuration
3-19
3
To delete a file, select System, File, Delete. Select the file name from the given list
by checking the tick box and then click Apply. Note that t
he file currently designated as
the startup code cannot be deleted.
Figure 3-10. Deleting Files
CLI – To download new firmware form a TFTP server, enter the IP address of the
TFTP server, select “opcode” as the file type, then enter the source and destination
file names. When the file has completed the download, set the new file to start up
the system and then restart the switch.
To start the new firmware, enter the “reload” command or reboot the system.
Note: It is possible to download a PoE PD_Controller file to a non-PoE switch, doing so
will not cause any adverse effects.
Console#copy tftp file 4-66
TFTP server ip address: 10.1.0.99
Choose file type:
1. config: 2. opcode 3. PD_Controller: <1-3>: 2
Source file name: MCD0121.bix
Destination file name: mcd0121.bix
/
Console#config
Console(config)#boot system opcode: mcd0121.bix 4-71
Console(config)#exit
Console#reload 4-22
To Next Page
Loading...
Need help?
General