Priority Commands
4-217
4
Priority Commands (Layer 3 and 4)
map ip port (Global Configuration)
Use this command to enable IP port mapping (i.e., class of service mapping for
TCP/UDP sockets). Use the no form to disable IP port mapping.
Syntax
[no] map ip port
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
Example
The following example shows how to enable TCP/UDP port mapping globally:
Table 4-67. Priority Commands (Layer 3 and 4)
Command Function Mode Page
map ip port Enables TCP class of service mapping GC 4-217
map ip port Maps TCP socket to a class of service IC 4-218
map ip precedence Enables IP precedence class of service mapping GC 4-218
map ip precedence Maps IP precedence value to a class of service IC 4-219
map ip dscp Enables IP DSCP class of service mapping GC 4-220
map ip dscp Maps IP DSCP value to a class of service IC 4-220
map access-list ip Sets the CoS value and corresponding output queue for
packets matching an ACL rule
IC 4-123
map access-list mac Sets the CoS value and corresponding output queue for
packets matching an ACL rule
IC 4-133
show map ip port Shows the IP port map PE 4-221
show map ip precedence Shows the IP precedence map PE 4-222
show map ip dscp Shows the IP DSCP map PE 4-223
show map access-list ip Shows CoS value mapped to an access list for an interface PE 4-124
show map access-list mac Shows CoS value mapped to an access list for an interface PE 4-134
Console(config)#map ip port
Console(config)#
To Next Page
Loading...
Need help?
General