Command Line Interface
4-32
4
• To specify a secure-site certificate, see “Replacing the Default Secure-site
Certificate” on page
3-58. Also refer to the copy command on page 4-66.
Example
Related Commands
ip http secure-port (4-32)
copy tftp https-certificate (4-66)
ip http secure-port
This command specifies the UDP port number used for HTTPS/SSL connection to
the switch’s web interface. Use the no form to restore the default port.
Syntax
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS/SSL.
(Range: 1-65535)
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same port.
• If you change the HTTPS port number, clients attempting to connect to the
HTTPS server must specify the port number in the URL, in this format:
https://device:port_number
Example
Related Commands
ip http secure-server (4-31)
Console(config)#ip http secure-server
Console(config)#
Console(config)#ip http secure-port 1000
Console(config)#
To Next Page
Loading...
Need help?
General