Command Line Interface
4-160
4
show interfaces switchport
Use this command to display the administrative and operational status of the
specified interfaces.
Syntax
show interfaces switchport [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
- port-channel channel-id (Range: 1-6)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 25.
Console#show interfaces switchport ethernet 1/22
Information of Eth 1/22
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#
Table 4-49. Show Interfaces Switchport Output - Description
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (
See page 4-156.)
Lacp status Shows if Link Aggregation Control Protocol has been enabled or disabled (See
page 4-166.)
VLAN membership mode Indicates membership mode as Trunk or Hybrid (See page 4-201.)
Ingress rule Shows if ingress filtering is enabled or disabled (See page 4-202.)
To Next Page
Loading...
Need help?
General