Command Line Interface
4-146
4
snmp-server group
Use this command to add an SNMP group, mapping SNMP users to SNMP views.
Use the no form to remove an SNMP group.
Syntax
snmp-server group groupname {v1 | v2c | v3 {auth | noauth | priv}}
[read
readview] [write writeview]
no snmp-server group groupname
• groupname - Name of an SNMP group. (Range: 1-32 characters)
• v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
• auth | noauth | priv - This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See
“Configuring SNMP”
on page 3-35 for further information about these authentication and
encryption options.
• readview - Defines the view for read access. (1-64 characters)
• writeview - Defines the view for write access. (1-64 characters)
Default Setting
Default groups: public (read only), private (read/write) – map to defaultview
readview - Every object belonging to the Internet OID space (1.3.6.1).
writeview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
• A group sets the access policy for the assigned users.
• When authentication is selected, the MD5 or or SHA algorithm is used as
specified in the
snmp-server user command.
• When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
Example
show snmp group
Four default groups are provided – SNMPv1 read-only access and read/write
access, and SNMPv2c read-only access and read/write access.
Command Mode
Privileged Exec
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
To Next Page
Loading...
Need help?
General