80209C_MHW_850-1650-1850_02-2020_ENG_pag. 105
4.12. Submenu AL.HB - Configuring the Heater Break alarm
Acronym Scrolling message Password Description
AL.HB HEATER BREAK ALARM
CONFIG
Level 1 Lets you configure the Heater Break alarm, i.e., the alarm that
trips when the heating element is outside normal operating
parameters.
The submenu is present if the CT1+CT2 input option was pre-
viously selected.
LOW.ON
HIG.ON
HI.OFF
TIME
THR.PE
OUT
LoAd
MSG.HB
BLK.HB
Alarm due to insuffi-
cient current draw
106
Alarm due to excessive
current draw
106
Alarm due to excessive
current draw
107
HB alarm trip delay 107
Percentage of HB
current compared to
calibration
107
Control output associat-
ed with HB alarm
107
Selecting type of
connected load
108
Message associated
with tripping of HB
alarm
108
Flashing of PV display 108
Parameter Pag.
To Next Page
Loading...
Need help?
General
